中文 | English | Deutsch | España | 日本語 | Portugal | Française | русский | Home | Contact
   Fan Speed Controller
   Card reader
   Bluetooth speaker
   3.0 Series
   Accessories
 
Company News
stw 5.25 inch card reader Teach you homemade brand chassis front card reader

stw 5.25 inch card reader Teach you homemade brand chassis front card reader

Step one: fixed IDE switch



Although the IDE switch on each side has a shrapnel (fixed role), but doesn't work in the drive panel strip openings.For fixed, the author USES two section of copper wire is 1.5 mm in diameter, and open up and down the drive panel used knife each open a small mouth, using switch shrapnel outward expansion force and support of the interaction in the drive panel through a copper wire to switch fixed. 


Step 2: fixed card reader in the drive panel


After fixed switch, fixed, card reader, must to polishing of optical drive panel opening, in order to increase the length and width, edge grinding, until card reader can be more compact in the.


Step 3: fixed card reader in the optical drive shell


The card reader on the drive panel is not difficult, difficult is how to make it solid in the optical drive shell.Because the card reader into drive part of the shell is hanging, to make the reader in the later use process to avoid from top to bottom and move around, have to put it in.To this end, the author makes full use of some of the computer case "waste" : chassis PCI baffle, floppy disk within the baffle, drive a baffle, and sponges and double-sided adhesive.The specific method is as follows:


The PCI baffle bent into a wave shape after the pad on the top of the card reader (drive shell for the inverted state);Fold floppy disk within the baffle into "U" shape, with double-sided adhesive in the proper position of the optical drive pan, and adjust the "U" shaped baffle of the two branches to the right Angle, so that after the installation of pan can just standing up to card reader, that to solve the problem of card reader of the up and down.To within the card doesn't make reader to slide, must be in it to resist it.Drive a damper on this the author use the case, because of its special shape, end on the card reader inside it, end on cd-rom of the end of the shell, using such a support to prevent the card reader to slide.At the same time in order to prevent it at the end of the reverse slip down when installation, the author on the optical drive pan stick with a sponge, use it to resist drives baffle.With these measures, the card reader can be fixed well in the optical drive shell.


Step 4: connect cable, installation


Due to the card reader need to occupy a USB interface, so use a rear USB connection components from the motherboard USB to a set of card reader, this USB connector on the chassis, use a USB cable can be connected to a card reader.Connect every power cord to the IDE switch again good, finally, the optical drive shell assembled again, and put it to the chassis drive installation, after installation in order to can cover on the chassis drives a baffle, when installation should push it as far as possible to the system unit.After the installation of the result as shown in figure 5, please.
 

After some efforts, could only be seen in the brand on the front of the card reader is finally on the general chassis "settled", is also very easy for you to use.Materials used in the transformation is more waste material, waste not only, also embodies the spirit of DIY.

www.stw.hk


Customer service | Contact
Copyright 2014 All Rights Reserved.Guangdong ICP for 11093975-1